
USB Station 2 User's Guide
Based on DSM 3.1
23 Chapter 3: Modify System Settings
IPv6 Setup
When you are configuring the LAN or Wireless interface, click the IPv6 Setup button to change the IPv6 settings.
USB Station 2 supports IPv4/IPv6 dual stack scheme. This means that both IPv4 and IPv6 can work
simultaneously on USB Station 2. The default setting for IPv6 is Auto.
On the IPv6 Setup page, choose between the different setup types:
Auto: USB Station 2 will automatically generate a local IPv6 address. This is generated based on USB Station
2's MAC address.
DHCP: USB Station 2 will automatically get an IPv6 address from the DHCP server which supports IPv6.
Manual: Set up IPv6 manually by entering IPv6 address, Prefix length, and Default gateway.
Off: Disable IPv6 support.
Note: If you want to join an IPv4 network environment with IPv6 address, you need to enable IPv6 Tunnel. See the
section below for more information.
PPPoE
Click the PPPoE on the left side if your USB Station 2 is connecting to a DSL or cable modem, and your Internet
Service Provider (ISP) uses PPPoE (Point to Point Protocol over Ethernet).
Komentáře k této Příručce