Synology RS2414+ Instalační příručka stáhnout pdf (Strana 11)

11 Chapter 2: Hardware Setup

Make Sure RackStation Recognizes New Memory Capacity

After installing a new memory module in your RackStation, we recommended checking whether the system

recognizes the new memory.

To check the memory of your RackStation:

1 Start up your RackStation. (See “Start Up Your RackStation” for more information.)

2 Install DSM. (See “Chapter 3: Install DSM on RackStation” for more information.)

3 Log in to Synology DiskStation Manager (DSM) with an account belonging to the administrators group.

4 Check Total Physical Memory in Main Menu > System Information.

If your RackStation does not recognize the memory or does not start up correctly, please make sure the memory

was correctly installed.

Remove a RAM Module from RackStation

1 Follow steps 1 and 2 of “Install a RAM Module” to remove the cover from your RackStation.

2 To remove the RAM module, follow the steps below:

a Release the ejectors on the memory slot by pushing them toward the sides.

b Hold the memory module by the edges and remove it from the slot.

3 Replace the top cover, slide it into place, and tighten the two back screws.

RS2414+

4096 MB

RackStation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Žádné komentáře

Synology RS2414+ Instalační příručka Strana 11