Synology RS2414+ Instalační příručka stáhnout pdf (Strana 8)

8 Chapter 2: Hardware Setup

 For 2.5” Hard Disks: Place the hard disk in the hard drive tray. Turn the tray upside down and tighten

screws into the four spots indicated below to secure the hard disk.

3 After securing the hard disk and tray, insert the loaded hard drive tray into the empty hard drive bay.

Important: Make sure the hard drive tray is completely inserted. Otherwise, the hard disk might not function

properly.

4 Push the handle to secure the hard drive tray.

5 Repeat the steps above to install all prepared hard disks.

6 Hard disk positions are numbered as shown below.

Note: If you want to set up a RAID configuration, we recommended all installed hard disks be the same size in

order to optimize hard disk capacity usage.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Žádné komentáře

Synology RS2414+ Instalační příručka Strana 8